High speed SD card and support for a second SD external card if required. Dual extruders on the main board, up to 5 more extruders on the expansion board.The bed heater channel is specifically designed for high current (18A). Connect via PC, tablet or smartphone on the same network to the on board web interface. Setup your printer and update the firmware through the web interface. All common 3D printer geometries are supported.
Expandable up to 7 extruders with Firmware support for mixing nozzles and remapping axes to use high power external drivers. Support for the PanelDue: a full colour graphic touch screen. Provided with Molex compatible plugs and crimps as well as ferrules for power and heater terminals. The PanelDue is a colour touch screen controller for the Duet and other 3dprinting electronics that support it.5V power from host 3D printer controller. 2-wire async serial interface with 3.3V signal level (5V tolerant input). Connections to the external SD card socket that is included on most compatible displays is available via a 10-way ribbon cable connector on version 2.0 PanelDue boards. 4-wire cable to connect the PanelDue to your controller board for the serial and power connections. The control board without a screen is also available however a 4.3", 5" or 7 SSD1963 LCD panel is required and the instructions on David Crocker's PanelDue blog must be followed. Based on the DuetWifi by Think3dPrint3d and Esher3d. This reproduction/modification is not endorsed or supported in any way by Think3dPrint3d or Escher3d. 1x Cloned Duet 2 wifi v1.04. 1x 4.3 inch PanelDue screen.
The item "3D Printer Duet 2 Wifi V1.04 Controller Board 32 Bit Mainboard +4.3 LCD Touch" is in sale since Friday, May 17, 2019. This item is in the category "Computers/Tablets & Networking\3D Printers & Supplies\Parts & Accessories". The seller is "kunkunh2009" and is located in HK. This item can be shipped worldwide.